記本開機錯誤程式碼解析大全

General 更新 2024年11月26日

  本文為大家帶來筆,希望能幫到大家。

  Symptom / Error ***開機錯誤程式碼*** FRU / Action in Sequence***檢查範圍及解決方法***

  10X

  101: Interrupt failure;***中斷故障***

  102: Timer failure;***計時器故障***

  103: Timer interrupt failure; ***計時器中斷故障***

  104: Protected mode failure; ***保護模式故障***

  105: Last 8042 command not accepted;

  107: NMI test failure;***NMI 測試失敗***

  108: Timer bus test failure.

  109: Low meg-chip select test. 1. System board. ***主機板問題***

  110 :***Planar parity.*** ***記憶體奇偶校驗出錯*** 1. Go to Memory Checkout 2. DIMM card.3. Detach the expansion unit if it is attached to the computer.4. System board.

  111:***I/O parity.*** 1. Go to Memory Checkout2. Expansion unit or port replicator.3. System board.

  11XX

  1101: Serial_A test failure.***A 序列口測試失敗*** 1. Serial device ***序列裝置***2. Communication cable ***相關通訊電纜***3. System board ***主機板***

  12XX

  1201: Serial_B test failure.***B 序列口測試失敗*** 1. System board ***infrared*** ***檢查主機板:紅外線口***

  158 :***Hard disk password was not set even though the supervisor password is set.*** ***超級使用者密碼已設,但硬碟密碼沒有設定*** 1. Set the password for hard disk drive.***設定硬碟密碼***

  159 :***Hard disk password is not set the same as the supervisor password.*** ***硬碟密碼與超級使用者密碼不一樣*** 1. Set the correct password for hard disk drive.***設定正確的硬碟密碼***

  161:***Dead battery.*** ***CMOS 電池不行*** 1. Go to Checking the Backup Battery 2. Backup battery.***CMOS 備份電池,在記憶體插槽旁邊***3. System board. ***主機板***

  163:***Time and date were not set.*** ***系統時間沒有設好或混亂*** 1. Set time and date.***設定正確的系 統時間*** 2. System board. ***主機板問題***

  173:***Configuration data was lost.*** ***CMOS 裝置配置資訊丟失*** 1. Select OK in the error screen; then set the time and date.***在 開機 ERROR 畫面上按OK,然後設定系統時間***2. Backup battery. ***CMOS 電池需要更換***3. System board. ***主機板問題***

  174:***Configuration error: Perform Checking the Installed Devices List before changing any FRUs.*** 1. Check device configuration.2. Hard disk drive assembly.3. System board.

  175

  177

  178175: EEPROM CRC #1 error.

  177: Supervisor password check sum error.

  178: EEPROM is not functional. 1. System board. ***檢查主機板***

  17XX

  1701: Hard disk controller failure. ***硬碟控制器故障***

  1780, 1790: Hard disk 0 error. ***主硬碟有問題***

  1781, 1791: Hard disk 1 error.***從硬碟有問題*** 1. Hard disk drive ***檢查硬碟***

  2. System board ***檢查主機板***

  183 :***Incorrect password entered at the supervisor password prompt.*** ***超級使用者開機密碼不對*** 1. Have the user examine the password.***請使用者檢查密碼***

  184:***Power-on password check sum error.*** ***Power-on 密碼有誤*** 1. Reset the power-on password in Easy-Setup.***重設Power-on 密碼***

  185:***The startup sequence is not valid. Suspect that power was off when the startup sequence was being updated.*** ***系統啟動順序無效,懷疑是更新啟動順序時電源關掉*** 1. Reset the startup sequence in Easy-Setup.***在Easy-Setup 重設啟動順序***

  186 :1. System board. ***檢查主機板***

  190:***A depleted battery pack was installed when the power was on.******開機時,機內筆記本電池已快耗盡了*** 1. Go to Checking the Battery Pack.***更換機內筆記本電池 ***

  191XX:***PM initialization error.*** ***PM 初始化錯誤*** 1. System board. ***檢查主機板***

  192:***Fan error.*** ***CPU 散熱風扇故障*** 1. Measure the voltage of the backup battery. If thevoltage is not correct, replace the backup battery.***檢查CMOS 備份電池的電壓,電壓不行時更換 電池*** 2. Fan ***要更換CPU風扇***3. System board ***主機板問題***

  195:***The configuration read from the hibernation area does not match the actual configuration.*** ***從休眠區域讀到的系統配置資訊與實際配置不同*** 1. Check if the config uration was changed. For example, check if the DIMM card is added.***檢查配置是否改動,記憶體有無增加等***

  196:***A read error occurred in the hibernation area of the hard disk drive.****** 從硬碟的休眠區域中讀寫時,發生錯誤*** 1. Run the hard disk drive test. ***測試硬碟***2. Hard disk drive.***檢查硬碟*** 199XX***Resume error.*** 1. System board.

  1XX 1. System board. 2XX ***記憶體問題***201: Memory data error.

  202: Memory line error 00-15.203: Memory line error 16-23.

  205: Memory test failure on on-boardmemory.

  221: ROM to RAM remap error. 1. Go to Memory Checkout.2. DIMM card. 3. System board. 225***Unsupported memory module.*** 1. Check if the supported DIMM is installed.2. DIMM card.3. System board.

  301, 303, 304, 305, 3XX

  ***301: Keyboard error.*** ***筆記本鍵盤故障,301這個故障經常出現,往往是筆記本剛開機時,不小心

  按住鍵盤所造成的,一般只要重啟電腦即可;*** 1. Go to Keyboard or Auxiliary Input Device Checkout 2. Keyboard.3. External numeric keypad. 4. External keyboard. 5. Keyboard/mouse cable.6. System board.

  601, 6XX ***601: Diskette drive or controller error.****** 軟碟機或軟碟機控制器故障*** 1. Go to Diskette Drive Checkout.2. Diskette drive assembly. ***軟碟機有沒有裝配好?***3. Diskette. 4. System board. ***檢查主機板 ***

  602:***Diskette read error.***; ***軟碟機讀故障*** 1. Go to Diskette Drive Checkout2. Diskette. 3. Diskette drive assembly.***軟碟機有沒有裝配好?***

  604:***Unacceptable ID was read from the diskette drive.***; 1. Go to Diskette Drive Checkout2. Diskette drive assembly.3. System board.

  2402 1. TV Out Card 24XX***2401: System board video error.*** ;***主機板顯示部分有問題*** 1. System board.***檢查主機板相關部 分***

  808X

  8081: PCMCIA presence test failure.***PCMCIA revision number also checked.***

  8082: PCMCIA register test failure. 1. PC Card slot assembly.2. PCMCIA device. 3. System board. 860X***Pointing device error when TrackPoint is disabled.******當指點杆禁用時,外接的指點裝置有故障***;

  8601: System bus error-8042 mouse interface.

  8602: External mouse error.***外接滑鼠故障***;

  8603: System bus error or mouse error. ***匯流排或滑鼠故障***; 1. External mouse. ***檢查外接滑鼠***;2. External keyboard. ***檢查外接鍵盤***;3. System board.***檢查主機板***;

  861X***Pointing device error when TrackPoint is enabled.******當指點杆啟用時,外接的指點裝置有故障***;

  8611: System bus error-I/F between 8042 and IPDC.

  8612: TrackPoint error.

  8613: System board or TrackPoint error. 1. Reseat the keyboard cable on the subcard.***把鍵盤連線主機板的線,重插拔一下***;2. Keyboard ***檢查鍵盤***;3. External mouse ***檢查 外接滑鼠***;4. Sub card ***主機板上連線鍵盤的子卡***;5. System board ***主機板***; I9990301I

  9990302I9990305

  I9990301: Hard disk error. ***硬碟有故障***;

  I9990302: Invalid hard disk boot record. ***無效的硬碟引導紀錄***;

  I9990305: No bootable device. ***無可用的啟動引導裝置***; 1. Check that the operating system is installed in the hard disk drive. If not, install the operating system.***檢查硬碟上有否安裝作業系統***;2. Reseat the boot device.***重新設定可啟動的裝置***;3. Check the startup sequence for the correct boot device.***檢查啟動順序是否跟裝置正確對應 ***;

  4. Check that the operating system has no failure and is installed correctly.***檢查電腦的操 作系統是否安裝正確***;

  I9990303***Bank-2 flash ROM check sum error.*** 1. System board.

  Other codes not listed above. 1. Go to Undetermined

記本開機錯誤程式碼解析大全
顯示卡驅動如何退回到前一個版本
相關知識
記本開機錯誤程式碼解析大全
記本開機錯誤程式碼解析大全
寬頻錯誤程式碼解析及簡單處理辦法
寬頻錯誤程式碼解析及簡單解決方法
由硬體引發藍屏的錯誤程式碼現象有哪些
網路連線錯誤程式碼有哪些
電腦開機藍屏程式碼大全
電腦藍屏錯誤程式碼怎麼回事
筆記本開機不進系統的解決方法
戴爾筆記本開機進不了系統解決辦法